1. The initial tension is too small. The tension of the stainless steel mesh belt leaving the drum is not enough to cause the stainless steel mesh belt to slip. This kind of situation usually occurs at startup. The solution is to adjust the tensioning device to increase the initial tension.
2. The rear roller bearing is damaged and does not rotate or the upper and lower roller bearings are damaged too much. The cause of the damage is that the tail floats too much, and the damaged or inflexible parts are not repaired and replaced in time, which increases the resistance and causes skidding.
3. The friction between the transmission drum and the stainless steel mesh belt is not enough to cause slipping. The reason is mostly water on the stainless steel mesh belt or humid environment. The solution is to add some rosin powder on the drum.
4. If the load of the stainless steel mesh belt is too large, it will slip if it exceeds the capacity of the motor. The advantage of slip at this time is to protect the motor. Otherwise, the motor will be burnt after a long time. But for operation, it is a slip accident. To solve the slipping phenomenon of the stainless steel mesh belt, we must first find out the reason for the slipping before taking effective measures.
5. Too fast starting speed can also cause slippage. You can start slowly at this time.
